Assembly - Baby Trend TS43 C Serie Manuel D'instructions

ASSEMBLY

REAR WHEELS
2) • Lean the stroller forward and press the
rear wheel post into the rear frame hub
until it clicks into place (Fig. 2a).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
• To remove, push tab outward and pull
wheel from hub (Fig. 2b).
MULTI-POSITION HANDLE
3) • To adjust the handle, press the release
buttons to move it up or down into a
comfortable position for the user (Fig. 3)
Note: Make sure the handle clicks into
place before using.
BUMPER BAR
WARNING:
use bumper bar to carry seat
with child inside. The bumper
bar is not a carrying handle.
4)
• Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it locks into place (Fig. 4a).
Note: The bumper bar must be securely
attached before using this product.
• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar
upwards to access the seat (Fig. 4b).
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 2a
Fig. 2b
Release Button
Fig. 3
Do not
Fig. 4a
Fig. 4b
PARENT TRAY
WARNING:
To avoid
burns, never put hot liquids
in cup holder. Avoid possible
tipping, do not place more
than 1 lb. (0.45kg) in cup
holder.
5) • Attach the parent tray to the frame by
wrapping the ends of the parent tray over
the handles of the frame and snapping
the strap buttons closed (Fig. 5).
ATTATCHING THE SEAT
™
• ONLY approved SNAP TECH products can be
used on the frame.
6)
• Make sure the seat fabric is properly
attached to the seat support bar. If the
seat fabric is unzipped, wrap the seat
fabric around the seat support bar (Fig.
6a) and zip the fabric closed.
• Attach the seat by lining up the seat
anchors on the side of the seat with the
anchors on the stroller frame and pushing
them together until they click securely
(Fig. 6b). The seat can face in either
direction, frontward or backward.
TO ADJUST SEAT
7) • The seat can be adjusted into upright,
reclined and carriage position. Pull the
recline button on the rear of the seat and
rotate the seat into the desired position
(Fig. 7a).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 5
Fig. 6b
Fig. 7a
6