Installation
1
Layout Dimensions - Stirrup Brackets (Standard)
When installing the partition components, consult
the applicable Mills Partition submittal drawing
for compartment layout dimensions.
Pilaster Centerline: Measure from the
back wall forward to the face of the
compartment, subtract 5/8" (16mm) and
mark this location on the floor ("A") . Mark
the same measurement on the opposite end
A
of your layout ("A1") and draw a straight line
connecting both marks .
For Freestanding (FS) Partitions: Refer
to submittal drawings and determine the
approximate location of the outside panels .
Establish dimensions "A" and "A1" as
explained above .
B
1a
Layout Dimensions - Continuous Brackets (Optional)
When installing the partition components,
consult the applicable Mills Partition submittal
drawing for compartment layout dimensions.
Pilaster centerline: Measure from
the back wall forward to the face of the
compartment, subtract 5/8" (16mm)
and mark this location on the floor ("A") .
Mark the same measurement on the
A
opposite end of your layout ("A1") and
draw a straight line connecting both
marks .
For Freestanding (FS) Partition: Refer
to submittal drawings and determine
the approximate location of the outside
panels . Establish dimensions "A" and
"A1" as explained above .
Panel centerline: Measure the stall width across the
B
back wall and place a mark at the base of the rear wall
("B") . Repeat this step for each panel, starting each
measurement from the last panel centerline ("B1") .
Bradley • HDWT-INSTR-010 Rev F; ECN 17-14-007
Powder Coated & Stainless Steel Restroom Partitions, Floor-Braced — Series 500
Panel centerline: Measure the stall width across the
back wall and place a mark at the base of the rear wall
("B") . Repeat this step for each panel, starting each
measurement from the last panel centerline ("B1") .
C L
"D"
*
Draw a plumb line on all walls from each pilaster and panel
centerline . From the highest point in the room, measure
C
18" (457mm) and 64" (1626mm) from the floor and place
a mark on the pilaster/panel plumb line . These marks
represent the hole center line of the stirrup brackets . Use a
level to transfer that mark to all other plumb lines ("C") .
C L
"C"
*
"C"
*
"A"
C L
Draw a plumb line on all walls from each pilaster and panel
C
centerline . From the highest point in the room, measure from
the floor and place a mark on the pilaster/panel plumb line at
dimension "C" for the respective bracket type (see table below) .
Use a level to transfer that mark to all other plumb lines ("D") .
"A"
"B"
C L
C L
"C"
*
"C"
"B"
*
"B1"
"A1"
Stainless
Steel
Aluminum
C L
C L
"D"
*
"D"
*
"B1"
"C"
"A1"
3/22/2018
C L
"C"
*
C L
64"
(1626mm)
"C"
*
C L
18"
(457mm)
Dim "C"
12-1/2"
(318mm)
12-1/4"
(311mm)
5