Bradley 500 Serie Manuel D'installation page 20

Powder Coated & Stainless Steel Restroom Partitions, Floor-Braced — Series 500
7a Continuous Spring-Loaded Piano Hinge (Optional)
Before installing the hinges, make sure the door openings are the appropriate size, all pilasters are plumb and
secured to the floor.
Refer to your submittal drawings to determine each specific door swing for your application. The door swing is
determined by facing the compartment from the outside. The image below can help determine the door swing type.
Continuous Piano Hinge
The part numbers listed are prefixes only and
are used to identify the appropriate door kit
based on your door swing as determined above .
Inswinging doors should have hinges mounted
on the inside of the stall while outswinging doors
should have hinges mounted on the outside of
the stall .
A
Place a door on a 12" (305mm) spacer and set the door gaps .
Standard hinge side gap is 9/32" (7mm) .
Position the hinge so it is plumb and centered within the 9/32"
B
(7mm) gap and centered top to bottom (approximately 1/4"
(6mm) down from the top of the door) .
Using the hinge as a template, drill Ø1/4" holes through the
C
door at the top and bottom holes . Secure the hinge to the door
using the #10-24 x 3/4" stainless barrel nuts and #10-24 x 3/4"
stainless shoulder screws provided
Check to make sure the hinge side gap is still at 9/32" (7mm) .
Using the hinge as a template, drill Ø1/4" holes through the
D
pilaster at the top and bottom holes . Secure the hinge to the
pilaster using the #10-24 x 3/4" stainless barrel nuts and
#10-24 x 1" stainless shoulder screws provided .
E
Drill Ø1/4" holes through the remaining hinge holes on the door
and pilaster . Secure with the fasteners provided .
20
Right-hand Left-hand
inswing inswing
(RHI) (LHI)
Part # Prefix HDWT-S0209
(left hand in, right hand out,
knuckles facing front)
Door
side
3/22/2018
Right-hand Left-hand
outswing outswing
(RHO) (LHO)
Door
side
Pilaster
side
Closed Door View
Bradley • HDWT-INSTR-010 Rev F; ECN 17-14-007
Installation
Part # Prefix HDWT-S0208
(right hand in, left hand out,
knuckles facing front)
Pilaster
side
Spacer 12" (305mm)