Horizon Fitness T202 Manuel Du Propriétaire page 5

ASSEMBLY STEP 3
HArDWArE BAG 3 CONTENTS :
BOLT (B) SPRING WASHER (C)
20 mm 15 mm
Qty: 4 Qty: 4
RUNNING
DECK
CONSOLE CABLE
BASE FRAME
8
T202-T203-CT7.1-OM-rev1.4.indd 8-9
All manuals and user guides at all-guides.com
Open hardware bag 3.
A
Pull lead wire through right console
B
FLAT WASHER (D)
mast. After pulling the lead wire through the
15 mm
mast, the top of the console cable should
Qty: 4
be located at the top of the mast. Detach and
discard the lead wire.
With the running deck in the raised
C
LEAD WIRE
position, attach the right console
mast to the base frame using 4 bolts
(b), 4 spring washers (c) and 4 flat
washers (d).
RIGHT CONSOLE MAST
NOTE: Be careful not to pinch any wires
while assembling the right console mast.
BOLTS (B)
SPRING WASHERS (C)
FLAT WASHERS (D)
ASSEMBLY STEP 4
HArDWArE BAG 4 CONTENTS :
BOLT (E) SPRING WASHER (C) FLAT WASHER (D)
15 mm 15 mm 15 mm
Qty: 4 Qty: 4 Qty: 4
CONSOLE
CONSOLE CABLES
ASSEMBLE
LEFT SIDE
FIRST
FLAT WASHERS (D)
SPRING WASHERS (C)
BOLTS (E)
CONSOLE MAST
Disengage the deck lock latch with your
A
foot to lower the running deck.
Open hardware bag 4.
B
gently place the console on top of the
C
console masts. Attach the left side first
using 2 bolts (e), 2 spring washers (c)
and 2 flat washers (d).
D Connect the console cables, carefully
tucking wires in masts to avoid damage.
Attach the right side of the console
E
using 2 bolts (e), 2 spring washers (c)
and 2 flat washers (d).
NOTE: Be careful not to pinch any wires
while assembling the masts.
F Before the first use, lubricate the treadmill
deck by following the instructions in the
MAINTENANCE section in the TREADMILL
gUIDE.
YOU ARE FINISHED!
8/5/10 8:32 AM
9