Safety; Intended Application; General Safety Instructions - Pepperl+Fuchs Vibracon Mini LVL-A1 Mise En Service

Mechanical data
Materials
Process connections
Cable
Plug type
Valve plug
QUICKON
valve plug
Connector M12 x 1

Safety

Intended application

The LVL-A1 may only be used as a level limit
switch for fluids and only in non-hazardous areas.
It must be installed in a fixed position in a tank or
pipe wall.

General safety instructions

Improper use may cause dangerous situations to
emanate from the LVL-A1.
The device may only be installed, connected up,
put into operation and maintained by trained and
instructed personnel taking into consideration
these instructions, the prevailing standards,
statutory regulations and – depending on the
application – certificates.
Warnings
Warnings are identified as follows:
Warning (danger, warning or caution)!
Type and source of danger, possible
consequences!
½
Action to avoid the danger.
Tuning fork, process connection and
housing: AISI 316L
Connection: PPSU
Thread G, R and NPT;
Sizes 1/2" and 3/4"
Cable requirements
Cross section max. 1.5 mm² (AWG 16);
Diameter 6 ... 9 mm
Cross section 0.34 ... 0.75 mm²;
Diameter 3.5 ... 6.5 mm
Pin assignment according
DIN EN 60947-5-2
23