Storing Preferred Frequencies In Your Own Frequency Groups - Monacor International JTS UF-10R/12 Mode D'emploi

Scanning all channels
1) Select the menu item
this has not been done already. Then press the
knob PUSH / CONTROL.
Scan All Groups
Press Setup or Enter to
start scan.
Press Exit to quit.
2) Press the button SETUP or the knob PUSH /
CONTROL to start scanning. The display shows
Scanning...
To exit at any time, press the button EXIT.
3) After scanning, the result list appears showing
all free channels:
Scan Result List
G: 1 CH: 1
Open Channel : 46
Group 1 has been selected. The bottom line indi-
cates the number of free channels, in this case
46 channels. In group 1, 48 channels are avail-
able, i. e. 2 channels are already being used.
4) All 12 groups can be selected when you turn the
knob PUSH / CONTROL.
5) To select a free channel, press the knob PUSH /
CONTROL so that the channel number is high-
lighted. Then turn the knob. When you turn the
knob, the channels already used are skipped.
6) Press the button SETUP to store the channel
selected for reception.
Scanning the channels of a group
1) If the selection menu for scanning (fig. 10) is not
shown, call it up via the menu item
main menu.
2) Turn the knob PUSH / CONTROL to select the
Current Group
menu item
knob.
Scan Current Group
G: 1 CH: 1
3) Turn the knob PUSH / CONTROL to select the
group.
4) Scanning of a group will always start with the
first channel which is automatically selected. To
check the first channel, press the knob PUSH /
16
All Groups
(fig. 10), if
Fig. 11
% .
Fig. 12
Scan
. Then press the
Fig. 13
CONTROL. After the check, the display will
OK
show
nel is not already being used. If the channel is
being used, it will be skipped and the next free
channel will be indicated.
5) To check the next free channel, press the knob
PUSH / CONTROL once again.
6) Press the button SETUP to store the channel for
reception.
6.2.4 Storing preferred frequencies
in your own frequency groups
It is possible to store up to 64 preferred frequencies
in your own six frequency groups.
1) Call up the following menu via the menu item
User Group
1. Custom Group
2. Clear Group
3. Return
2) The first menu item is selected. Press the knob
PUSH / CONTROL to call up the following setup
menu:
Setup User Group
G:U1
---.--- MHz
3) The group number is selected. Turn the knob
PUSH / CONTROL to select the group where the
frequency is to be stored.
4) Press the knob PUSH / CONTROL so that the
channel number is selected. Turn the knob to
select the channel number where the frequency
of the
is to be stored.
5) Press the knob once again so that the digits
before the decimal point are selected. Turn the
knob to set the transmission frequency in steps
of 1 MHz.
6) For fine adjustment in steps of 0.025 MHz,
press the knob once again so that the digits
after the decimal point are highlighted. Then
turn the knob.
7) Press the button SETUP to store the frequency
selected.
8) To store further frequencies, repeat steps 2 – 7.
9) To exit all menus, press the button EXIT three
times.
after the channel number if the chan-
of the main menu:
CH:1
Fig. 14
Fig. 15