Fixed-Speed Type; Other Features; Default Setting - HTW ADMIRA -D-035ADMR32 Manuel De L'utilisateur Et D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 86

Fixed-speed Type

Room
Temperature
Outdoor
(For models with low-temp cooling systems)
Temperature
NOTE: Room relative humidity less than 80%. If the air conditioner operates in excess of this
gure, the surface of the air conditioner may attract condensation. Please sets the vertical air
ow louver to its maximum angle (vertically to the oor), and set HIGH fan mode.
To further optimize the performance of your unit, do the following:
Keep doors and windows closed.
Limit energy usage by using TIMER ON and TIMER OFF functions.
Do not block air inlets or outlets.
Regularly inspect and clean air lters.

Other features

Default Setting

When the air conditioner restarts after a power
failure, it will default to the factory settings
(AUTO mode, AUTO fan, 24°C). This may cause
inconsistencies on the remote control and
unit panel. Use your remote control to update
the status.
Auto-Restart (some models)
In case of power failure, the system will
immediately stop. When power returns, the
Operation light on the indoor unit will flash. To
restart the unit, press the ON/OFF button on
the remote control. If the system has an auto
restart function, the unit will restart using the
same settings.
Three-minute protection feature
(some models)
A protection feature prevents the air
conditioner from being activated for
approximately 3 minutes when it restarts
immediately after operation.
Page10
COOL mode
17°C-32°C (62 ° F-90 ° F)
18°C-43°C (64 ° F-109 ° F)
-7°C-43°C (19 ° F-109 ° F)
18°C-52°C (64 ° F-126 ° F)
(For special tropical models)
HEAT mode
0°C-30°C
(32 ° F-86 ° F)
-7°C-24°C
(19 ° F-75 ° F)
Louver Angle Memory Function
(some models)
Some models are designed with a louver angle
memory function. When the unit restarts after a
power failure, the angle of the horizontal louvers
will automatically return to the previous position.
The angle of the horizontal louver should not be
set too small as condensation may form and drip
into the machine. To reset the louver, press the
manual button, which will reset the horizontal
louver settings.
Refrigerant Leak Detection System
(some models)
The indoor unit will automatically display "EC"
or "EL0C"or ash LEDS (model dependent )
when it detects refrigerant leakage.
DRY mode
10°C-32°C (50 ° F-90 ° F)
11°C-43°C (52 ° F-109 ° F)
18°C-43°C (64 ° F-109 ° F)
18°C-52°C (64 ° F-126 ° F)
(For special tropical models)

Publicité

Table des Matières
loading

Table des Matières