LaserLiner RollPilot S6 Mode D'emploi page 8

To measure from wall to wall
3
1. Position the device with the rear of
the measuring wheel against the
wall.
2. Move the measuring wheel straight
to the other wall.
3. Read off the measured value and
add the diameter of the wheel.
To achieve accurate measurement results, the guide bar must be held
!
at the same angle during the entire measurement. A vertical position
is recommended.
To measure from wall to spot
4
1. Position the device with the rear of
the measuring wheel against the
wall.
2. Move the measuring wheel straight
to the marked spot.
3. Read off the measured value and
add the radius of the wheel.
To measure from spot to spot
5
1. Position the pointer (8) on the fi rst
marked spot.
2. Move the measuring wheel straight
to the other marked spot.
3. Read off measured value.
08
GB
R + Measurement
R + Measurement
Measurement
+ R