Table des Matières
Publicité
EN
OPERATING INSTRUCTIONS
ANCHORAGE DEVICE (COMPLYING TO EN795-B and CEN TS 1645 :2013)
INSTRUCTIONS FOR USE:
This manual must be translated (according to regulations) by the dealer, in the language of the country where the
equipment is used.
This manual must be read and understood by the user before using the PPE.
The test methods described in the standards do not represent actual usage conditions. It is therefore important to
study each work situation and that each user is fully trained in different techniques in order to know the limits of
the various devices.
The use of this PPE is restricted to qualified persons properly trained or working under the direct responsibility of a
competent superior. The user's safety depends on the continuing efficacy of the PPE, its strength and the proper
understanding of the instructions in this manual.
The user is personally responsible for any use of this PPE which does not comply with the requirements of this
manual and in the case of non-compliance with the security measures applicable to PPE specified by this manual.
The use of this PPE is restricted to persons in good health, certain medical conditions may affect the safety of the
user, in case of doubt, contact a physician. (for example: drugs, alcohol and psychotropic drugs, others... )
Adhere strictly to the instructions for use, verification, maintenance and storage.
This product is inseparable from a comprehensive fall protection system (EN363), whose function is to minimize the
risk of body injury from falls. This product must be removed after the use. This product should be a personal issue
item, where this is applicable.
Before any use, refer to the recommendations for use for each component of the system.
After use, remove the device and store it properly.
The fall arrest harness (EN361) is the only body grip to be allowed for use
with a fall arrest system.
The fall arrest harness (EN361) may be connected to its attachment point
A, to a connection element or component in personal protection fall
arrest systems (restraint systems, work positioning systems (EN358), fall
arrest systems (EN353-1, EN353-2, EN355, EN360), access systems via
ropes and rescue systems).
The fall arrest harness (EN361) is connected to other elements of the
system by connectors (EN362).
In these cases, follow the instructions described in their own manual.
LV301 STRUCTURAL MATERIALS AND DESCRIPTION:
Sling (1): In stainless steel 7x19, diameter 8mm, with a PE protective sheath. Length 1m. R>37KN. 2 clamps in copper
(7), and 2 loops in stainless steel.
Cable (2): Stainless steel diameter 8mm 7x19; R>37KN
Karabiner anchor (3): in zinc-coat steel. Opening 17mm. R>23KN. 2 per product
Tensioner (4): Stainless steel, with screw M12 to adjust the tension inside the cable. 2 loops on each side to be
connected to the cable and to the sling.
Energy absorber (5): Stainless steel. On side to be connected to the sling, the other one to be swaged to the cable.
Clamp cable (7):: in stainless steel, clamp the cable thanks 4 screws.
Sling (1)
Cable (2)
Karabiner anchor (3)
Tensioner (4)
Energy absorber (5)
Clamp cable (7)
WARNING:
This anchoring device (EN795) will never be directly connected to a harness.
This anchoring device shall only be used in a PPE fall arrest system. Any other use can jeopardize the safety of the
user.
INTRODUCTION:
①
(See reference table)
ESTABLISHMENT AND/ OR ADJUSTMENTS:
The installation of the device must be made according to the instructions of the installation manual of the device.
LV301 Anchorage device
13.09.2016
7/15
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE
Publicité
Table des Matières
