Ribimex Ribitech PRKIT10PF/2 Manuel D'instructions Et D'utilisation page 23

2. Insert depth gauge (11) into & through the opening [b].
3. Adjust the depth gauge (to required depth work).
4. Screw tight the wing nut [a] on the fixture of additional handle (10).
5. Now the bit drill will only penetrate into the item being bored until
the depth gauge makes contact with the item's surface.
4.6- Switching ON and OFF (Fig.7)
Attention! Before starting working with the rotary hammer, check that the voltage shown
on the machine's rating plate is the same as the mains voltage being used.
1. To switch tool on:
Press on the On/Off trigger switch (4).
The tool remains switched on for as long as On/Off switch (4) is depressed.
2. To switch tool off:
Release the On/Off trigger switch (4).
The tool switches off immediately but accessory keeps on running on for a
little.
4.7- Speed (Fig.7)
You may adjust the speed by rotating the knob (7).
4.8- Functions (Fig.7 + Fig.8a,8b,8c,8d)
Remark: When the words 'left' or 'right' are used in the following manual, this is always from the
viewpoint of the tool's user.
4.8.1. Hammer and drill function
Turn the lever switch (8) to the left side to position (
depress the lock button and then turn the lever selector (9) to the
right, so that the arrow coincides with the mark (
4.8.2. Drill Stop
You can deactivate the drilling action of the hammer drill when
using it for chiseling work.
Turn the lever switch (8) to the left side to position (
depress the lock button and then turn the lever selector (9) to the
left, so that the arrow coincides with the mark ( ).
4.8.3. Hammer Stop and Rotary Stop
Turn the lever switch (8) to the right side to position ( ); depress
the lock button and then turn the lever selector (9) to the left so
that the arrow coincides with the mark ( ).
4.8.4. Hammer Stop
The hammer drill is equipped with a hammer stop facility for
smooth drilling.
Turn the lever switch (8) to the right side to position ( );
depress the lock button and then turn the lever selector (9) to the
right so that the arrow coincides with the mark (
);
).
Hammer ON – Rotary ON
);
Hammer ON – Rotary OFF
Hammer OFF – Rotary OFF
Hammer OFF – Rotary ON
).
Fig.6
Fig.7
Fig.8a
Fig.8b
Fig.8c
Fig.8d
Page 23 / 36