Ribimex Ribitech PRKIT10PF/2 Manuel D'instructions Et D'utilisation page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.2.2- Removing an accessory (Fig.3 & 3b)
1. To remove the accessory, pull locking sleeve (2) backwards and hold it.
2. Remove the accessory and release locking sleeve (2).
3. Clean the accessory and rub it over with a small amount of machine grease.
Fig.3
4.3- Manual chuck
4.3.1- Inserting an accessory
1. Open chuck jaws with the key.
2. Insert the accessory into the chuck as inside as possible and tighten the chuck jaws with the key.
3. Ensure that accessory is securely locked in by firmly pulling on it.
4.3.2- Removing an accessory
1. To remove the accessory, open chuck jaws with the key
2. Remove the accessory from the chuck.
3. Clean the accessory and rub it over with a small amount of machine grease.
4.4- Additional handle (Fig.4)
DANGER! Injury hazard! Ensure that the plug is never in the socket when fitting or removing the
handle
For safety reasons, always use the rotary hammer only with additional handle
1. Release the fixture of additional handle (10) by turning the
handle two or three times anticlockwise (towards the left).
2. Pass the clamping ring over the chuck and locate it on to the
body of the drill.
Then rotate the additional handle to the desired position.
3. Secure the additional handle again by turning the handle (10)
clockwise.
Note: Make sure to adjust the additional handle (10) so as to achieve a better
working position.
4.5- Depth gauge (Fig. 5 + 6 )
The tool is supplied with a depth stop (11) used for drilling holes to
required depth.
Note: The depth gauge (11) is only recommended for use only when
working without hammer action.
1. Release the wing nut [a] on the fixture of additional handle (10)
until opening [b] is clear.
Fig.3a
Fig.3b
Fig.4
Fig.5
Page 22 / 36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

531039

Table des Matières