Ribimex Ribitech PRKIT10PF/2 Manuel D'instructions Et D'utilisation page 21

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Always check that the voltage of the power supply matches the voltage indicated on the tool's rating
plate.
12. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
13. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above.
14. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
15. Have your tool repaired by a qualified person
Repairs should only be carried out by qualified persons using original spare parts, otherwise it may
result in considerable danger to the user.
ATTENTION! The machine's operation generates a certain level of noise. National or local
regulations may restrict the use of the machine to certain hours. Check with your local authority.
IV- GETTING STARTED
Before any intervention on product, ensure that product is disconnected from its power source.
4.1- Unpacking (Fig.2)
- Remove product from its packaging.
- Check that tool and accessories are not damage
Content:
a- Hammer Drill
b- Depth gauge
c- Spanner
d- Flat chisel
e- Pointed chisel
f- Drill bits 8mm, 10mm, 12mm
g- Dust protection cap
h- Manual chuck with key
Fig.2
4.2- SDS chuck
4.2.1- Inserting an accessory (Fig.3 & 3a)
Note1: Use only a clean work tool. Before insertion into the chuck, lubricate the shaft of the
accessory lightly with machine grease.
Note2: the word accessory used in this paragraph refers to the bits, chisels and manual chuck
1. Pull locking sleeve (2) backwards and hold it.
2. Insert the accessory into the chuck (1) as inside as possible, and then release locking sleeve (2).
3. Ensure that accessory is securely locked in by firmly pulling on it.
Page 21 / 36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

531039

Table des Matières