Installation - Zanussi ZFU20201WA Notice D'utilisation

Problem
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
There is too much frost.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
www.zanussi.com
Possible cause
The product temperature is too
high.
The room temperature is too high.
The temperature regulator is not
set correctly.
The Fast Freeze function is switch-
ed on.
The temperature regulator is not
set correctly.
Many products are stored at the
same time.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The temperature regulator is not
set correctly.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Set a higher temperature.
Refer to" Fast Freeze function".
Set a lower temperature.
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circu-
late freely around the back of the cabinet. To
ensure best performance, if the appliance is
positioned below an overhanging wall unit, the
minimum distance between the top of the cab-
inet and the wall unit must be at least 100
mm . Ideally, however, the appliance should
not be positioned below overhanging wall
units. Accurate levelling is ensured by one or
more adjustable feet at the base of the cabi-
net.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be
easily accessible after installation.
Solution
45