STOK Tower SCC0140 Manuel D'utilisation page 11

STEP 3: ASSEMBLING THE LEGS AND BASE
TO THE STAND
See Figures 8 - 9.
Remove the following from the blister pack:
HH - 4 Bolts (M6 x 55)
II
- 9 Flat washers (6 mm)
JJ - 9 Lock washers (6 mm)
KK - 9 Hex nuts (M6)
LL - 3 Bolts (M6 x 16)
NN - 2 Bolts (M6 x 62)
 There are two U-shaped leg sections.The legs that angle
outward are for the front of the grill. The straight legs are
for the back of the grill.
 Make sure the rear leg section is placed with the dimple
facing up.
 Set the legs onto the base.
 Insert four (4) bolts (HH) through the base, leg sections,
and brace as shown.
 Slide a washer (II), lock washer (JJ), and nut (KK) over
each bolt and finger-tighten.
To attach the assembled base, legs, and brace to the
supports:
 Align the side panel tabs with the slots in the base.
BRACE
LEG SECTION
(FRONT)
SLOT FOR
SIDE PANEL TAB
BASE
BOLT (4 - HH)
Fig. 8
ASSEMBLY
 Insert two (2) bolts (LL) through the two rounded tabs and
one (1) bolt (LL) through the front support and base.
 Slide a washer (II), lock washer (JJ), and nut (KK) over
each bolt and finger-tighten.
 Insert two (2) bolts (NN) through the rear support tabs,
base, rear legs and brace.
 Slide a washer (II), lock washer (JJ), and nut (KK) over
each bolt.
 Using an adjustable wrench, securely tighten all bolts.
(FOR BOLTS - LL)
NUT
LOCK WASHER
WASHER
LEG SECTION
(REAR)
DIMPLE
Fig. 9
11
ROUNDED TAB
REAR SUPPORT
TAB (FOR BOLTS - NN)
LEGS
BASE
FRONT
SUPPORT
BOLT
(2 - NN)
SIDE PANEL TAB
(INSERT INTO BASE)
NUT
LOCK
WASHER
WASHER
REAR
SUPPORT
TAB
BOLT
(3 - LL)