Set Up; Operation By Ac Adapter; Operation By Batteries - Tanita WB-3000 Manuel De L'utilisateur

Use the scale in a firm, flat and stable location.
AC adapter is much preferable when the scale will be used continuously.
1) Insert the AC adapter jack into the AC adapter inlet on the back side of display.
2) Plug the AC adapter into the power outlet.
WARNING
• In order to reduce the risk of electric shock, never insert or remove the power code with wet hands.
CAUTION
• This equipment must be used with the included AC adapter only.
1-1)
1-2)
Image

6. Set up

To obtain the highest level of accuracy, please make sure that all four (4) feet are touching on the
floor evenly.
For further accuracy and security, please position the two (2) adjustable supporting feet on the base
(found under the front cover) until they just make contact with the floor (do not overextend)
• Do not position it anywhere that is subject to direct sunlight, near heating equipment, or directly in
the path of an air conditioner outlet.
• Do not use it anywhere that is subject significant temperature change.
• Do not position it anywhere that it either damp or subject to high humidity.
CAUTION
• Put the weighing platform on a flat, level surface.

7. Operation by AC adapter

8. Operation by batteries

1) When the batteries start to run low, "Lo" appears on the display panel as a warning.
2) Pull up the battery case which located on top of display. All batteries should be immediately
replaced with new ones at the same time.
• Do not use a combination of alkaline and manganese batteries, as such an arrangement may result
in equipment failure.
• Rechargeable batteries are NOT recommended use.
3) Push down the battery case completely.
* Insert new batteries such that the negative terminals of the batteries are pushed up against the coils
within the battery housing.
5