Geberit AquaClean Sela Instructions De Montage page 26

EN
Checking the remote control
Prerequisites
The function test with the control panel has been
completed successfully and the control panel is
ready for operation.
The remote control must be closer than 1 m
to the WC to enable it to detect the WC
during commissioning.
1
Open the battery compartment and insert
battery type CR2032.
To assign the remote control to a specific
device:
press the < + > button on the control panel
and the remote control at the same time,
until the <Shower> button lights up for 2
seconds on the remote control. The remote
control can then only be used for the
assigned shower toilet.
26
≤100
1
2
2
Press the shower button.
Result
The spray arm is extended, the shower starts.
3
Increase or decrease the spray intensity by
pressing the < – > / < + > buttons.
4
Change the spray arm position by pressing
the arrow keys.
5
Start or stop the oscillating spray by
pressing the arrow keys simultaneously.
6
Press the shower button.
Result
The shower stops.
All functions of the remote control have been
checked.
B1070-005 © 09-2016
966.102.00.0 (05)