SECTION 3
STEEL GUARD
STAND OFF GUIDE
P/N 0558002393
GUIDE AGAINST
STRAIGHT EDGE
OR FREE-HAND
CUT
Figure 3-4 Installation and Operation of Steel Heat Shield Guards
97
ADJUST GUIDE BY TURNING
IN A CLOCKWISE DIRECTION
ONLY. THIS WILL PREVENT
ACCIDENTAL LOOSENING
OF SHIELD.
IF GUIDE IS TOO
TIGHT ON SHIELD,
OPEN SLOT WITH
SCREWDRIVER.
THIN GAUGE MATERIALS
CAN BE CUT WITH 1.6 mm (1/16")
TORCH-TO-WORK DISTANCE
ADJUST TO 4.8 mm (3/16") FOR
MATERIALS OVER 6.4 mm (1/4")
THICK
1.6 mm (1/16") TO
6.4 mm (1/4")
TORCH-TO-WORK
IF TOO LOOSE, CLOSE
SLOT WITH VISE OR
LARGE PLIERS.
OPERATION