Troubleshooting; Appliance; Ice Maker/Dispenser - Thermador T18BD Serie Guide D'utilisation Et D'entretien

Troubleshooting

Appliance

Fault
Appliance has no cooling
capacity. Interior light does not
function. The display does not
illuminate.
The refrigerating unit switches
on more and more frequently
and for longer.
The temperature in the freezer
compartment is too cold.
The interior light does not
function.
The appliance is giving off
odors.

Ice maker/Dispenser

Fault
Ice maker does not appear
to be running.
Small ice cubes over a prolonged
period.
Possible cause
Power failure; the fuse has actuated;
the mains plug has not been inserted
properly.
Appliance door opened frequently.
Large amounts of fresh food have been
put away.
The ventilation openings have been
covered.
Temperature has been set too low.
The bulb is defective.
Light switch is sticking.
Strongly smelling food is not sealed.
Possible cause
The ice maker is not connected to the
power supply.
The ice maker has no water supply.
The freezer compartment temperature
is too high.
Other domestic appliances which use water
are in operation.
Water filter must be changed.
Wrong water pressure.
A wrong water valve has been installed.
The manufacturer is not liable for damage to property due to an incorrect installation
or water connection.
Remedial action
Check that the power is on. The fuse must
be switched on. Check that the mains plug is
plugged in.
Do not open the door unnecessarily.
Switch on Super function.
Remove obstacles and dirt.
Select a warmer temperature (see "Setting
the temperature").
Change the bulb (see "Changing the bulb").
Check whether it can be moved.
Clean the appliance. Pack strong-smelling
foods in airtight containers (see "Odors").
Remedial action
Call customer service.
Ensure that the water supply line is connected
properly.
Check temperature of the freezer compartment.
If required, lower the temperature.
Avoid using e.g. a dishwasher, washing machine
or shower at the same time.
Instructions for changing the water filter can be
found in the enclosed installation instructions.
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
3
Self-tapping valves and /
16
saddle valves reduce the water pressure and may
eventually block the pipe.
inch (4.76 mm)
21