Setting The Temperature; Super Function; Setup Mode - Thermador T18BD Serie Guide D'utilisation Et D'entretien

Setting the
temperature
The temperature can be set from +7 °F
to –9 °F (–14 °C to –23 °C).
We recommend a setting of
0 °F (–18 °C).
The temperature can be changed with
the + buttons (warmer) or – (colder).
The temperature can be set at one
degree intervalls.
To adjust the required temperature:

Activate the Setup mode with the
< >
or button.
The symbol is displayed.
FREEZER

Set the required temperature with
the + (warmer) or – (colder) buttons.
Depending on the model, the
appliance can also be switched off
or switched to Vacation mode via
the temperature setting. When the
highest temperature has been
reached, OFF is displayed.

Super function

The Super function is used to freeze
large quantities of fresh food and should
be switched on some hours before the
fresh food is placed in the freezer.
In general, 4–6 hours is adequate. If the
maximum freezing capacity is used,
24 hours are required.
When the Super function is activated,
the appliance is cooled as cold as
possible to a preset temperature set at
the factory.
The function is activated by pressing the
SUPER button.
The symbol and the Super
SUPER
temperature are displayed.
The function is ended by pressing the
SUPER button again.
After 2 days the appliance automatically
switches back to the temperature which
was set before Super freezing.

Setup mode

There are several menus for adjusting
the appliance functions to individual
requirements. These adjustments can
be made in Setup mode.
To activate Setup mode:

Press the SETUP button.
The first menu (temperature unit) is
displayed.
To switch to the next menu:

< >
Press the or button.
The next menu and the current setting
(usually / ) are displayed.
ON OFF
To select between the different setting
options within one menu:

Press the + or – button.
A modified setting is saved when
the next menu is selected with the
< >
or button.
To end Setup mode:

Press the SETUP button.
All modified settings are saved.
If no button is pressed within
12 seconds, Setup mode ends
automatically. All modified settings
are saved. The required
temperature is displayed again.
11