Krups EA9000 Serie Mode D'emploi page 17

KRUPS
SERIE EA9000
Fill the cup with the volume of milk indicated on the screen and
n
place it under the coffee spouts.
The cup must be placed close to the cleaning container, under the steam
n
nozzle, at the back of the niche.
However, do not press the cleaning container (11) with the cup; otherwise,
n
it might break off.
3
You can lower or raise the coffee nozzle to suit the size of your cup. The
n
steam nozzle will descend just behind the coffee nozzles. Caution: the
maximum height of the cup is defined by the coffee nozzles; do not tilt the
cup to place it under the coffee nozzles.
To use a large cup (or mug), you might have to remove the small drip tray (6).
n
Press the "OK" button.
n
Milk preheating phase.
n
Milk frothing phase:
n
the milk is then frothed
according to the chosen recipe.
4
The nozzle moves up and draws back to return to its cleaning
n
container.
Remove the cup when the screen shows: Your milk is ready.
n
Rinsing the nozzle.
n
5
The nozzle is rinsed automatically. You must wait for this rinsing to be
n
complete before starting the next preparation.
n
Hot water
Press the "Hot water" button on the touch screen.
n
If the machine detects no water when you request this recipe, it will ask
n
you to fill the tank.
1
28
Choosing the volume.
n
The screen displays the last volume requested. You can modify this
n
volume using the arrows on the left and right of the indicated value.
2
Place your cup under the coffee nozzles.
n
To use a large cup (or mug), you must remove the small drip tray.
n
Make sure that the cup fits under the coffee nozzles without
interference.
The cup must be placed close to the cleaning container.
n
3
Caution: use a cup that matches the volume of the recipe. The
n
maximum height of the cup is defined by the coffee nozzles; do not
tilt the cup to place it under the coffee nozzles.
Caution: Do not press the cleaning container (11) with the cup;
n
otherwise, it might break off.
Press OK. The steam nozzle then comes out of its cleaning
n
container to stop just above your cup.
You will need to modify the steam nozzle position using the + and -
n
symbols according to your convenience. If the steam nozzle is too high
from the bottom of the cup, there is a risk of splashing. Caution: The
4 nozzle must not touch the bottom of the cup either.
Press the OK button on the touch screen.
n
Dispensing hot water through the steam nozzle.
n
If necessary, the machine goes into preheating mode, then begins to
n
dispense hot water.
You can modify the volume of your preparation using the arrows on
n
the left and right of the indicated value.
Press "Stop" to stop the recipe.
n
5
!
Important: The production of hot water does not stop immediately after you press the
(it takes 3 to 5 seconds to stop). Press the button sufficiently early to avoid overflows.
ENGLISH
"Stop" button
29