Automatic Cleaning Programmes - Krups EA9000 Serie Mode D'emploi

Masquer les pouces Voir aussi pour EA9000 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

KRUPS
SERIE EA9000
Replace the ground coffee funnel.
n
Close the funnel lid. The funnel lid is then locked. If the machine asks you
n
whether you have taken out the funnel: press the OK button on the touch
4
screen.
Cleaning of ground coffee funnel completed.
n
n
Changing the cleaning liquid bottle
The machine can request the replacement of the cleaning liquid bottle, but you can also make this
request.
You can access the "Maintenance" menu from the main menu by
n
pressing the "Maintenance" tab.
You must always use this programme so that the counters can be updated.
n
Press the "Changing the cleaning liquid bottle" button on the touch screen.
1
n
To quit the "Maintenance" menu, press the "Maintenance" tab.
n
Open the left door (15).
n
Pull out the drawer (19) of the cleaning liquid bottle.
n
Unscrew the bottle to be changed. Use only Krups bottles. The use of other
n
products that are incompatible or not approved by Krups will invalidate
the guarantee.
Remove the cap from the new bottle of cleaning liquid then screw it onto
n
2
the drawer without turning too tightly (maximum one and a half turns) (19).
Screw in the new bottle. Place the liquid bottle in the axis of the
n
drawer.
Screw at least two turns.
n
Push the drawer to the back.
n
Close the door.
n
Press OK.
3
n
This programme is finished.
n
40

8.2 Automatic cleaning programmes

n
Automatic cleaning programme of the coffee circuit
A message on the screen will indicate when a cleaning programme needs to be run for the appliance.
Cleaning is required around every 360 preparations.
To run this cleaning programme, you will need a recipient with a capacity of at least 0.6 litres which
can fit underneath the coffee nozzle, and a KRUPS cleaning tablet (two of which are supplied in the
Welcome Pack).
The automatic cleaning programme has three phases: one cleaning cycle and two rinsing cycles. It
lasts around 20 minutes.
Protect your worktop from any splashes during the cleaning and descaling cycles, especially if it is
made of marble, stone or wood.
!
Caution:
You are not obliged to carry out the cleaning programme immediately the appliance
requests it, but it must be carried out reasonably soon.
Only use KRUPS cleaning tablets otherwise the guarantee will not cover any material
damage caused by the use of other brands of tablets. Cleaning tablets are available from
your KRUPS After-Sales Service Centre.
!
Caution:
To respect the guarantee conditions, the cleaning cycle must be carried out when the
appliance requests you not to postpone it further.
Here are the main steps in this programme. Otherwise, just follow the instructions on the screens
displayed by the machine.
You can access the "Maintenance" menu from the main menu
n
by pressing the "Maintenance" tab.
Press the "Cleaning coffee circuit" button on the touch screen.
n
1
To quit the "Maintenance" menu, press the "Maintenance" tab.
n
Empty the used coffee collector, remove and empty the drip trays, and fill the water tank.
n
2
ENGLISH
41

Publicité

Table des Matières
loading

Table des Matières