Setup; Unfolding The Handle; Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Lawn-Boy 10634 Mode D'emploi

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.

Unfolding the Handle

WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(Figure 3).
Important: Route the cables to the outside of the
handle as you install the handle.
1. Handle knob (2)
2. Move the handle to the operating position (Figure 3).
3. Install the handle knobs and tighten them firmly by
hand.
Figure 3
Installing the Recoil-starter
Rope in the Rope Guide
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 4).
1. Recoil-starter rope

Filling the Engine with Oil

Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 5) and pour about 3/4 of
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 20 oz. (0.59 l), type: 10W-30 or SAE
30 detergent oil with an API service classification of
SJ or higher.
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube.
5. Remove the dipstick and read the oil level on the
dipstick (Figure 5).
5
Figure 4
2. Rope guide
Figure 5