Adjusting The Cutting Height; Starting The Engine; Using The Self-Propel Drive - Lawn-Boy 10634 Mode D'emploi

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all 4 wheels to the
same height.
Note: To raise the machine, move all the cutting-height
levers forward; to lower the machine, move the all the
cutting-height levers rearward (Figure 9).
1. Raise the machine
Note: The cutting height settings are 1 inch (25 mm); 1-1/2
inch (38 mm); 2 inches (51 mm); 2-1/2 inches (64 mm); 3
inches (76 mm); 3-1/2 inches (89 mm); and 4 inches (102
mm).
Figure 9
2. Lower the machine

Starting the Engine

1. Hold the blade-control bar (Figure 10) against the
handle.
1. Blade-control bar
2. Turn the ignition key (Figure 11) or pull recoil-start
handle (Figure 12).
Note: If the machine does not start after several
attempts, contact an Authorized Service Dealer.

Using the Self-propel Drive

To operate the self-propel drive, squeeze the self-propel drive
bar (Figure 13) toward the handle and hold it.
1. Self-propel drive bar
8
Figure 10
Figure 11
Figure 12
Figure 13