Adjusting The Self-Propel Drive Cable; Cleaning The Underside Of The Machine - Lawn-Boy 10634 Mode D'emploi

Adjusting the Self-propel Drive
Cable
Whenever you install a new self-propel cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive cable.
1. Loosen the cable-support nut (Figure 25).
1. 1 to 1-1/2 inches (25 to 38
mm)
2. Self-propel drive bar
3. Cable jacket
2. Hold the self-propel bail 1 to 1-1/2 inches (25 to 38
mm) from the handle (Figure 25).
3. Pull down the cable jacket (toward the machine) until
there is no slack in the cable (Figure 25).
4. Tighten the nut on the cable support.
5. Release the self-propel drive bar and ensure that the
cable is loose.
Note: The cable must be loose with the self-propel
drive bar in the released position; otherwise, the
machine may creep when you disengage the bar.
Cleaning the underside of the
Machine
Service Interval: After each use
WARNING
The machine may dislodge material from under the
machine housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle).
• Do not allow bystanders in the area.
Figure 25
4. Cable-support nut
5. Cable support
1. With the engine running on a flat paved surface, spray
a stream of water in front of the right rear wheel
(Figure 26).
The water will splash into the path of the blade,
cleaning out the clippings.
2. When no more clippings come out, stop the water and
move the machine to a dry area.
3. Run the engine for a few minutes to dry the housing
to prevent it from rusting.
14
Figure 26