Adjusting The Self-Propel Drive Cable; Replacing The Blade - Lawn-Boy 10605 Mode D'emploi

1. Blade nuts
2. Stiffener
3. Blade
4. Remove the blade (Figure 17).
5. Remove the blade driver and disk (Figure 17).
6. Remove the blade stop system shield (Figure 17).
7. Brush or blow out debris from the inside of the
shield and around all the parts.
8. Install the blade stop system shield that you
previously removed.
9. Install the blade driver and disk that you previously
removed.
10. Install the blade and the stiffener that you previously
removed (Figure 17).
11. Install the blade nuts and torque them to 15 to
27 ft-lb (20 to 37 N-m).

Replacing the Blade

Service Interval: Yearly—Replace the blade or have
it sharpened (more frequently if the
edge dulls quickly).
Important: You will need a torque wrench to install
the blade properly . If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If
the blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened and
balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
Figure 17
4. Blade driver
5. Disk
6. Blade stop system shield
1. Disconnect the spark plug wire from the spark plug.
Refer to Preparing for Maintenance.
2. Tip the mower onto its side with the air filter up.
3. Remove the 2 blade nuts and the stiffener (Figure 18).
1. Blade nuts
4. Remove the blade (Figure 18).
5. Install the new blade (Figure 18).
6. Install the stiffener you previously removed.
7. Install the blade nuts and torque them to 15 to
27 ft-lb (20 to 37 N-m).
Adjusting the Self-propel Drive
Cable
Self-propel models only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1. Loosen the cable support nut (Figure 19).
13
Figure 18
2. Stiffener