Publicité
Les langues disponibles
Les langues disponibles
Sump
1. Press Switch 'A' to the 'OFF' (0) position
2. Gently pull the drawer out as far as possible. (See Fig.3)
3. Remove the water tank by lifting upwards.
4. Disconnect the electrical connector, located on the left side
of the sump, by fi rst loosening the two retaining screws and
gently withdrawing the connector. (See Fig.8)
5. Release the lower sump locking tabs by turning 90º, this
allows the sump to be lifted completely from its location. (See
Fig.9)
6. Gently lift up the sump assembly, taking care to keep level
so as not to spill any water. Sit the assembly in the sink. (See
Fig.10)
7. Release the two upper sump locking tabs by turning 90º,
then lift off the sump lid. (See Fig.11)
8. Carefully tilt, as shown, so that the liquid drains out of the
sump. (See Fig.12)
9. Put a small amount of washing up liquid into the sump, and
using the supplied brush, gently clean all surfaces including
the metal disc and the rubber seal located in the top grooved
surface. Do not remove the rubber seals. (See Fig.13 and 14)
10. When cleaned, thoroughly rinse the sump with clean
water.
11. Clean the outlet surface of the sump lid with the brush and
fl ush out thoroughly with water. (See Fig.15 & 16)
12. Reverse the above steps to reassemble.
Air fi lter
1. Gently pull the drawer out as far as possible. (See Fig.3).
2. Press Switch 'A' to the 'OFF' (0) position (See Fig.2)
3. Remove the tank and place in a sink with the cap facing
upwards.
4. Gently slide upwards the air fi lter plastic holder. (See Fig.17)
5. Remove the fi lter combination from the plastic holder.
6. Gently rinse with water in the sink and dry with fabric towel
before returning.
7. Replace the fi lter combination making sure that the course
black fi lter is in contact with the plastic holder. (See Fig.18)
8. Replace the tank.
9. Press Switch 'A' to the 'ON' ( I ) position (See Fig.2).
10. Close the drawer fully.
Recycling.
For electrical products sold within the European
Community. At the end of the electrical products useful
life it should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of
purchase. Within this period, we undertake to repair or
exchange this product free of charge (excluding lamps &
subject to availability) provided it has been installed and
operated in accordance with these instructions. Should you
require after sales service or should you need to purchase any
spares, please contact the retailer from whom the appliance
was purchased or contact the service number relevant to your
country on the warranty card. Please do not return a faulty
product to us in the fi rst instance as this may result in the
loss or damage and delay in providing you with a satisfactory
service.
Please retain your receipt as proof of purchase.
15
Publicité
