Mountfield AZURO 240 Notice De Montage Et D'utilisation page 30

EN
necessary to count on the height of the arch [1] (cca 125 mm). Measure and mark the place of cutting
B. Better measure twice before you cut off the legs!
At the place B cut off the protruding part of the legs with a metal saw. In the distance of 20 mm from
the cut off ends drill a hole, having the diameter of 8,6 mm (max. 9mm), at the same level as the other
openings in the legs
STEP 2: SET UP THE DIVIDED LEGS AND ARCHES
The arches [1] push fi rmly into both divided legs [2] so that the openings in the arch were aligned with
the openings in the legs (Abb. C-2). Screw the joints together by means of the screws [11] and nuts [12].
STEP 3: AFFIX THE PLASTIC STEPS TO THE LEGS
NOTE: Proceed from the bottom ends of the legs upwards. Take care to affi x the steps to the legs in
the same manner. Once assembled it shall not be possible to dismantle the steps without causing any
damage to them. The legs are symmetrical, however, their lower bendings must look to each other in
opposite directions (Abb. C-4).
Attach the two-part sleeve [9] to Leg [2] or [4] at the pressed place (Abb. C-3) and fi x them with the
rubber circle [11 Push the step [8] onto the sleeve from above, until the locks on the sleeves get behind
the upper edge of the step opening.
Proceed step by step from the bottom ends of the legs upwards.
STEP 4: AFFIX THE HANDRAILS OF THE LADDER TO THE LEGS
Insert the handrails of the ladder [3] from above into the openings in the platform [7] and then insert
the narrowed ends of the legs [2] and [4] (Abb. C-5). Keep the openings in the handrails [2] aligned
with the openings in the legs [2] and [4] and with those in the platform [7].
Screw all parts together with the screws [10] and the tube nuts [13] in all corners of the platform [7].
Insert the tube nuts from the outer side of the platform.
STEP 5: AFFIX THE LADDER TO THE REINFORCEMENT
Take the reinforcement of the ladder [6] and lay it down beside the arches of the legs [1] inwards the
ladder. Align the openings in the reinforcement [6] with the openings in the arches [1] (Abb. C-6).
After the openings have been centred, screw the parts by means of the tube nuts [13] and the screws
[14].
Note: The tube nuts must be tightened safely but do not tighten them to excess, the parts of the ladder
might be damaged, if the tube nuts are tightened to exces. Now, the ladder is ready for use.
USE
The ladder is intended to be used in above-ground swimming pools and partially in embedded
swimming pools. The reinforcement serves for the stabilization of the branch construction of the ladder,
which branch is intended to be shortened.
WARNING: Insert the ladder into the swimming pool in such a manner that its reinforcement should be
outside the SP – see Fig.7. If you use the ladder the other way round, then the liner might be damaged.
For safety and practical reasons, do not leave the ladder in the SP without any reason. In the period
when you do not use the SP, clean the ladder, dry it off, and keep it out of reach of children.
• 30 •