Mountfield AZURO 240 Notice De Montage Et D'utilisation page 29

Properties of the SP felt underlay
Fibres used for the manufacture of the felt underlay are subject to ageing after some time if exposed
to light (so called photo-degradation). Therefore, it is not good to store the felt underlay out of the pac-
kage. It should be kept in the cardboard box or liner stabilised against the UV radiation.
The unwoven textile is resistant against the petrol, perchloro-compounds, oil and other chemicals of
similar nature, against mildews and other micro-organisms.
It does not have any harmful properties. Installation of the felt underlay for a SP with corner fill
The SP felt underlay is to be installed at the moment when we have set up the SP wall and provided the
internal fi ll of sieved pit sand. Unroll the felt underlay and spread it over the bottom inside the SP, centre
and smoothen any possible wrinkles. Cut off the felt underlay several centimet- res above the corner fill
(Abb. A-1). Take care to prevent any small stone or other simi- lar sharp objects from entering the upper
side of the felt underlay.
B) INSTRUCTION FOR THE ASSEMBLY OF SWIMMING POOL
LADDER DE LUXE
Before the assembly of the ladder, read kindly the following instructions:
• Read carefully the instruction for use.
• Defi ne the place for the entry to and exit from the SP.
• The ladder has to rest on a smooth and hard surface for the sake of its stability.
• The ladder must not be used by more than one person at once. THE LOAD CARRYING CAPACITY OF
THE LADDER IS 90 KG.
• When entering or leaving the SP using the ladder, have your face always turned to the ladder, do not
rock or swing.
• Never dive directly from the ladder, do not jump from the ladder to the SP.
• Never swim underneath the ladder or to the area as between the ladder and the SP wall. You could
get drowned.
• Should the ladder be not used, remove them from the SP. However, never let the ladder in the reach
of children.
• During periods when the SP is not used, we recommend to clean, dry and store the ladder.
• Don't use the ladder for any other but intended purpose.
• Any persons suffering from a limited mobility and small children may use the ladder only being
accompanied by other people without any physical handicap.
STEP 1: ADJUST THE LENGTH OF THE DIRECT LEGS AND
ASSEMBLE THE LEGS
The access ladder is manufactured for above-ground swimming pools, having the maximum height of
a wall of 23 cm, and adjusted in such a manner that it should be possible to use it also in embedded
swimming pools. If your SP is built as an above-ground swimming pool, then apply Step 2.
ADJUSTMENT OF THE LADDER FOR EMBEDDED SWIMMING POOLS
For the sake of safety, both the entry side and exit side of the ladder must have the same inclination
with respect to the horizontal plane. Therefore, according to the location of the ladder adjust the length
of the divided legs [2] so that the ladder stand upright. When determining the length A (Abb. C-1) it is
• 29 •
EN