Mountfield AZURO 240 Notice De Montage Et D'utilisation page 20

EN
PART 2 – PREPARATION OF THE SITE
STEP A – SELECTION OF THE SITE FOR THE ERECTION OF THE
SWIMMING POOL
1. GROUND
• Pay special attention to the selection of a proper site for your SP.
• Select a large area as fl at and horizontal as possible.
• Select a place on a dry, solid and sun-bathed earth. So not erect
the SP on asphalt, tarpaper, gravel, peat swamp, wood, underfl
ooded ground, or over any underground premises such as water
reservoirs, sumps, sewers etc.
• Check whether there are any plants on such an area that could
grow through the liner of your SP. If it be so, then we recommend
to treat the site with a total herbicide (pursuant to the instructions)
sufficiently in advance prior to the commencement of the ground
works or, as the case may be, to lay down a black garden liner
under the body of the SP.
• Any sloppy areas have to be levelled by digging upper positions
away. Do not fi ll depressions. If necessary, hire a system for the
removal of soil.
The SP has not been designed for embedding to the ground.
2. CONDITIONS TO BE AVOIDED
Do not place the SP in the proximity of or immediately in any of the
following places:
• In the vicinity of areas and objects available to children and
animals that could make the access to the SP easier for them. If it
be to the contrary, it is necessary to secure the surroundings of the
SP in order children and animals may be prevented from entering
the SP.
• Grass, stones, roots. Grass will get rotten bellow the pool liner and
stones and roots will damage the liner of the SP.
• Branches of trees hanging over the SP. In the vicinity of trees and
higher bushes. Leaves and other impurities fall directly into the SP and increase its pollution.
• Suspended electrical lines and clothes lines.
• Places with a poor natural water drainage capacity as the environs of the SP may get fl ooded.
• Any areas recently treated with oil-based pesticides, chemicals or fertilisers. In such a case use a felt
underlay bellow your SP made of geo-textile material.
3. PLAN IN ADVANCE
Do you wish to add an adjacent platform later on? Allow some space for it. Keep in mind that the
surrounding vegetation (trees, bushes) shall grow on and may put your SP into the shade.
Will you use the accessories to the SP or some other system that need to be connected to a power
supply? Position your SP in a way allowing for the installation of such systems in compliance with safety
regulations (see the Instruction manual to this product). Any possible installation of an electrical socket
and an earth-leakage circuit-breaker must be carried out by a qualifi ed electrician.
• 20 •
NO
YES