Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V4.1
4.
Slide the upper stem (#10) towards the
controller unit (#7). Take care to note the
direction of the cut slot of the upper stem (#10)
which should be pulled underneath the support
of the controller unit (#7).
5.
Secure by tightening the knob nut (#8) which is located
under the controller unit (#7).
6.
Adjust the lower stem (#12) so that when you stand
upright with the detector in your hand that the search
coil (#14) is level with and about 1/2 to 2 in. above the
ground with your arm relaxed at your side.
7.
Tighten the stem lock (#11) counterclockwise to lock the stem in place.
8.
Loosen the search coil knobs (#13) at
the search coil assembly (#14), then
adjust the search coil to the desired
angle and then tighten the knobs just
enough to keep the search coil (#14)
from rotating or wobbling.
IMPORTANT! The search coil (#14) should be parallel with the ground.
9.
To adjust the armrest (#2), loosen the one
screw at the bottom of the armrest. Adjust the
armrest so that it should be near the end of
your forearm. Tighten the screw to secure the
armrest in place.
Visit www.princessauto.com for more information
Metal Detector
8603052
7
Publicité
Table des Matières
