Power Fist 8603052 Manuel D'utilisateur page 12

8603052
reading on the detector. This is caused by highly mineralized ground or
interference from power lines, radio stations, etc. As a general rule, reduce
the sensitivity to prevent excessive false signals.
TARGET ELIMINATION SETTING
1. In the Normal Operating State, press the SET button twice (2 times) until
the highlight icon is flashing.
IMPORTANT! The iron nail encircled by the highlight icon means that it
is selected.
2. Press the MODE button. An "X" mark which means "eliminate" will be put
on the selected target.
3. Use the
detector to respond to.
4. Press the MODE button again, the "X" mark will be removed and the target
is restored.
5. Repeat the above steps for setting the other targets.
6. Press the ENTER button to confirm the setting and return to the Normal
Operating State.
TARGET PRECISION
To find the exact location of the target, press and hold the target button, the audio
tone will raise loudly when approaching the target, and the screen will be flashing
segments in the Target Precision display when the exact location is reached.
TONE LOUDNESS SETTING
1. In the Normal Operating State, press the SET button three times (3 times)
until the Tone Volume Icon flashes.
2. Use the
IMPORTANT! There are four levels of volume adjustment. The more segments
displayed, the higher the volume level.
3. Press the ENTER button to confirm the setting and return to the Normal
Operating State.
12
or buttons to select the targets that you do not want the
or buttons to increase or decrease the tone volume loudness.
Metal Detector
For technical questions call 1-800-665-8685
V4.1