Sensitivity Adjustment - Power Fist 8603052 Manuel D'utilisateur

V4.1
Mode
NORMAL OPERATION STATE
1. Turn on the detector by pressing the Power button once (1 time).
2. The SENS and DEPTH icons (with other icons) should appear on the display.
3. The detector enters in the Normal Operation State.
4. Press the POWER button again to turn off the power supply to the detector.
BATTERIES CONDITION INDICATOR
1. Indicates the condition of the batteries in the battery box. There are four
levels (segments) that will indicate the condition of the batteries.
2. All four segments indicates the batteries are in good condition.
3. One segment is the minimum power at which the detector can be operated.
When the indicator reaches this level and is flashing, it is time to replace
the batteries.

SENSITIVITY ADJUSTMENT

1. In the Normal Operating State, press the SET button and the SENS icon
will flash.
2. Use the
3. Press the ENTER button to confirm the setting and return to the Normal
Operating State.
IMPORTANT! There are four levels of sensitivity adjustment. The more
segments displayed, the higher the sensitivity level. A high level of
sensitivity should always be used for searching since a high level of
sensitivity can detect the deepest and smallest targets, however, at a high
level of sensitivity you may face the problem of a false signal. A false signal
occurs when something shouldn't sound like a good target but creates a
Visit www.princessauto.com for more information
or buttons to increase or decrease the sensitivity.
Metal Detector
The factory default is set up originally for
low speed sweep searching when you
switch on the detector. To speed up the
pace of detection, press the Mode button.
IMPORTANT! The fast setting mode
may reduce the detection accuracy.
8603052
11