Factory Setting - Power Fist 8603052 Manuel D'utilisateur

V4.1

FACTORY SETTING

To restore the detector to the factory setting, press at the same time the ENTER
and the POWER buttons. The detector will return to the original factory settings.
SEARCH TESTING
To familiarize yourself and learn how the detector reacts to different metals by
placing different objects on the ground and passing the detector near and over
the objects. You can test the detector indoor or outdoor.
INDOOR TESTING
1. Turn on the detector and make sure that the detector is in the Normal
Operating State.
2. Place the detector on a table and remove any metal objects including
watches, rings or jewelry that you are wearing.
3. Adjust the search coil so that the searching face points towards the ceiling.
4. Slowly sweep a sample of the target that you want the detector to find at
about 2 to 3 in. above the face of the search coil. The detector produces a
tone for the target when it is detected.
5. Repeat with an eliminated target, such as the pull-tab from an aluminum can.
6. Seep the pull-tab above the face of the search coil. You should note that
the detector does not respond to the eliminated target.
OUTDOOR TESTING
1. Turn on the detector and make sure that the detector is in the Normal
Operating State.
2. Find an area on the ground outside where there are no metal objects.
3. Bury a few sample objects at a distance of 1 to 2 ft apart as targets for
the testing.
4. While holding the search coil level to the ground about 1 to 2 in. above the
surface, slowly move the search coil over the area where you have placed
the samples, sweeping the search coil in a side-to-side motion.
IMPORTANT! When a sample is being detected, a tone will be generated.
5. Slowly lift up the search coil, the depth indicator on the LCD display will
Visit www.princessauto.com for more information
Metal Detector 8603052
13