Description; Assembly - Active OLIVATOR E 20 Manuel D'instructions

3
2
1
1. Carter engine
2. Switch / speed regulator
3. Perno pipe coupling
4. Clamping ring-14
5. Transmission pipe
6. Grip
7. Carter referring to "Y"
INSTRUCTIONS FOR ASSEMBLY - PHOTO PAG. 2 - 3
- Open the box;
- For mounting of scuotitore need a Allen key 3 in the
envelope.
- Make sure the 4 screws (13) of the box referring to "Y"
(7) are relaxed - photo B -
- Engage the transmission pipe (5), on the other side
all'impugnatura Black (6), in indictment box "Y" (7)
maintaining the holes (11) in a vertical position
- photo A -
Alternatively rotate clockwise and counterclockwise until
you hear a click, the two plastic pivots (16) must be fixed
in the center of the two respective holes (11) of the tube
(6); this means that the graft was successful - photo C -
Tighten now, with the key Allen, the 4 screws (13)
-Photos B -
We now move to the side engine recognizable even to the
proximity dell'impugnatura in black rubber (6) - photos D -
Loosen the locking ring (4) and repeat the clutch and
simultaneous rotation, having raised the same pipe
coupling pin (3) - photos E -
Again handle up to get the click of the pin (3) in the hole
(12) provided on the tube - photo D -
Now tighten well, but only manually, the clamping ring (4)
- Photos F -
Be careful to match the sectors sull'asta present plans

4. DESCRIPTION

10
ON DEMAND
4
6
5
9
ON DEMAND

5. ASSEMBLY

15
8
7
ON DEMAND
8. Balls vibrating rotor
9. Extension (1 mt)
10. Grip delta
11. Battery
12. Backpack
13. Battery charger
within the pipe joints and solidarity to the engine and the
postponement to "Y" - photos I -
MOUNT EXTENSION (Photo G - H)
-Take off the cap (15), after having loosened the ring (14)
below the power plant.
Fill-extender (9) and return to firmly tighten the ring (14).
Keep the cap for subsequent reuse.
WARNING: This configuration maneuverability of
the deteriorating and the effort to sustain
increases.Then you should use only where strictly
necessary.
ELECTRICAL CONNECTION
- Connect the 2 terminals to a 12V battery.
- Check the correct polarity of the connection
- Red Fork + POSITIVE
- Black Tree - NEGATIVE
- Every time you connect the unit is well ensure the
integrity of the cables.
- If you notice cuts, abrasions or deformation of the cable
that is terminal or engine housings,
scuotitore not use it, but go immediately to a
Authorized Center for monitoring and possible repair.
GB
ENGLISH
11
12
13