Starting A Program; Safely Shut Down Acr ® 3; Save A Log File; Print A Snapshot - BriskHeat ACR 3 Hot Bonder Manuel D'instructions

Temperature Profile Reading and Alarm Settings
High Shutdown:
Displays the high temperature shutdown set point
High Alarm:
Displays the high alarm set point
Set point:
Displays the current system set point
Actual:
Displays the current actual control temperature as measured or calculated
Low Alarm:
Displays the low alarm set point
Low Shutdown:
Displays the low temperature shutdown set point
Thermocouple Readings
Displays the actual temperature of each individual sensor. A grey field indicates a disabled
sensor. A red field indicates a faulty input: i.e. open, high temperature, or low temperature.

Starting a program:

1. Attach the necessary cords, sensors and hoses as described in Equipment Setup and Start-
up on page 7.
2. Touch button or
the OPERATING menu.
3. Select the program from the drop down list
Note: See page 15 for instructions on how to Write a New Program.
4. Touch the button. The Repair Data screen displays.
5. Enter the necessary repair data or skip by pressing ENTER.
6. To enter the repair data, touch the data field to be entered.
7. Using the keyboard on the data entry screen, enter the required data and touch ENTER.
8. When all necessary data has been entered, press the ENTER button and the program starts.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
at top of screen to access
.
11
®
Safely Shut Down ACR 3:
1. Touch button at the top of the screen to access the SYSTEM
menu.
2. Touch button.
3. Press OK to shut down hot bonder.
4. Flip the red main power switch to the OFF position. The main power switch is not illuminated
when off.

Save a Log File:

1. After successful run, Press YES button to save log file and data. Press NO button to exit
without saving.

Print a Snapshot:

This function prints a snap shot of the cure cycle.
1. Touch PRINT button in the OPERATING menu to print snapshot of cure cycle.

Silence the Alarm:

This function silences the audible alarm.
1. Touch ALARM button in upper right screen that appears after audible alarm starts.

Hold a Program:

This function holds / pauses a program after it has begun.
1. Touch HOLD button in the OPERATING menu to hold a program.
2. Touch RUN button in the OPERATING menu to resume program.

Cancel a Program with a Fall:

This function allows you to cancel a program with a gradual fall.
1. Touch FALL button in the OPERATING menu to cancel program with a fall.
2. Press YES button to save log file and data. Press NO button to exit without saving.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
12