Important Safety Instructions; Agency Approvals; Introduction; Package Contents - BriskHeat ACR 3 Hot Bonder Manuel D'instructions

IMPORTANT SAFETY INSTRUCTIONS

DANGER
A person who has not read and
understood all operating
Instructions is not qualified to
operate this product.
DANGER

Do not immerse or spray hot bonder with liquid.

Keep volatile or combustible material away from
hot bonder when in use.

Use hot bonder only in approved locations.

Keep sharp metal objects away from hot bonder.

The operator is not to open the enclosure. Only a
trained service person may open the enclosure.

Disconnect the power cord before opening the
enclosure. Turning off the power switch leaves
dangerous voltage levels accessible to the service
person.

If the equipment is used in a manner not specified
by the manufacturer, the protection provided by
the equipment can be impaired.

The unit must be connected to Protective Earth
Grounding.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury or death.
WARNING
End-User Must Comply to the Following:

Only qualified personnel are allowed to connect electrical wiring.

All electrical wiring must follow local electrical codes and highly recommend following NEC Article 427.

The end-user is responsible for providing a suitable disconnecting device.

The end-user is responsible for providing suitable electrical protection device. It is highly recommended that a
ground fault circuit breaker is used.

If a Protective Earth Conductor must be removed during service, it must be replaced.
Failure to observe these warnings may result in personal injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
WARNING

Agency Approvals

Approval valid only when installed with UL listed
products.
CAUTION

Inspect hot bonder before use.

Do not use hot bonder if damaged.

Do not repair damaged or faulty hot bonders.

Do not position the equipment so that it is difficult
to operate the disconnect device. The power cord
is the disconnect device.

Do not crush or apply severe physical stress on
hot bonder or cord assembly.

Unplug hot bonder when not in use.

®
Only use power cords provided by BriskHeat
Failure to observe these warnings may result in personal
injury or damage to the heater.
3

INTRODUCTION

® ®
The BriskHeat ACR 3 Hot Bonder is the world's most complete, all-in-one equipment to
debulk and cure resins, prepregs, adhesives, fibers, and more. This equipment controls the
heat and vacuum for on-the-spot composite and metal bond repairs / cures. These systems
are portable and self-contained. For successful operation of this system, read and understand
these instructions prior to use.

PACKAGE CONTENTS


®
ACR 3 Hot Bonder unit

An accessory storage case containing:

One 10ft (3m) input power cord with plug per zone (20937-120 or 20937-240)

One 5ft (1.5m) heater output power cord per zone (20936-01)

10 J-type thermocouples with mini connectors per zone (11510)

10 Standard connector adapters for thermocouple receptacles per zone (41253)

Two 10ft (3m) vacuum hoses per zone (20938)

Two vacuum bag feed-throughs per zone (20931)

One extra printer ribbon (40795-02) and roll of printer paper (40795-01) per zone

USB flash disk (11514-03)
If any items are missing from the package, call your local distributor or BriskHeat
(800) 848-7673 (U.S. and Canada) or (614) 294-3376.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
®
at
4