Save A Single Program File To Usb Drive; Save All Program Files To Usb Drive; Load A Single Program File From Usb Drive; Load All Program Files From Usb Drive - BriskHeat ACR 3 Hot Bonder Manuel D'instructions

Save a Single Program File to USB Drive:

This function saves a single program file to a USB flash disk (thumb drive). Use the USB
flash disk to transfer programs to another hot bonder or archive programs.
1. Access the SYSTEM menu.
2. Touch SAVE PROGRAMS TO USB DRIVE button.
3. Select the desired program file from the drop down menu.
4. Touch SAVE SELECTED PROGRAM TO USB DRIVE button.
5. Insert USB flash drive (thumb drive) in USB port located on the operator console. Touch OK
button.
6. Follow remaining on-screen commands.

Save All Program Files to USB Drive:

This function saves all stored program files to a USB flash disk (thumb drive). Use the USB flash
disk to transfer programs to another hot bonder or archive programs.
1. Access the SYSTEM menu.
2. Touch SAVE PROGRAM TO USB DRIVE button.
3. Touch SAVE ALL PROGRAMS TO USB DRIVE button.
4. Insert USB flash drive (thumb drive) in USB port located on the operator console. Touch OK
button.
5. Follow remaining on-screen commands.

Load a Single Program File from USB Drive:

This function loads a single program from a USB flash disk (thumb drive) to your hot bonder.
®
NOTE: The ACR 3 Hot Bonder is capable of storing up to 30 programs in its internal
memory.
1. Access the SYSTEM menu.
2. Touch LOAD PROGRAMS FROM USB DRIVE button.
3. Insert USB flash drive (thumb drive) in USB port located on the operator console. Touch OK
button.
4. Select the desired program file from the drop down menu.
5. Touch LOAD SELECTED PROGRAM FROM USB DRIVE button.
6. Follow remaining on-screen commands.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
23

Load All Program Files from USB Drive:

This function loads all stored programs from a USB flash disk (thumb drive) to your hot bonder.
®
NOTE: The ACR 3 Hot Bonder is capable of storing up to 30 programs in its internal
memory.
1. Access the SYSTEM menu.
2. Touch LOAD PROGRAMS FROM USB DRIVE button.
3. Touch LOAD ALL PROGRAM FROM USB DRIVE button.
4. Insert USB flash drive (thumb drive) in USB port located on the operator console. Touch OK
button.
5. Follow remaining on-screen commands.

Shut Down System:

®
This function safely shuts down the ACR 3. This function is recommended to provide optimal
performance.
1. Access the SYSTEM menu.
2. Touch button.
3. Press OK to shut down hot bonder.
4. Flip the red main power switch to the OFF position. The main power switch is not illuminated
when off.

Change System Date and Time:

1. Access the SYSTEM menu.
2. In the DATE / TIME SETUP section of the SYSTEM menu, touch the desired field. Enter the
new date / time.
3. Touch LOAD NEW DATE / TIME button.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
24