Switching Point Programming; Checking - Soehnle 3010 Mode D'emploi

9. Application Programs

9.6 Switching Point Programming

Four switching points can be set in the Terminal 3010.
The switching points are used for the application programs "Checking", "Count
Checking" and "Dosing".
Setting the switching points
Press the Switch-Point key.
The first switching point is displayed, indicated by the arrow in the display.
01
02
03
04
Set the value using the Tare key or Function key.
If you press the key briefly, the value increases / decreases individually. If you
hold the key, the value increases / decreases continuously.
Confirm by pressing the Switch-Point key.
The display jumps to the next switching point.
Again set the value using the Tare key and Function key.
Confirm by pressing the Switch-Point key.
Repeat this procedure until all four switching points have been set.

9.7 Checking

The switching points for the internal LED lamps or the external lamps (optional
available) are used for checking.
Enter the setpoints as check values as follows:
Enter the switching points as described in Chapter 9.6.
Activate the Checking function in the setting mode (see 470.702.119 User
Mode).
Switching Point Value
S1 0
S2
Lower tolerance
S3
Upper tolerance
S4
Upper tolerance
9
49