The System Is In Summer Mode, During The Night Time; The System Is In Summer Heat Wave Mode, During The Daytime; The System Is In Summer Heat Wave Mode, During The Night Time; Temporary - murprotec CTA 2 Mode D'emploi

4.1.1.4. The system is in SUMMER mode, during the NIGHT TIME

The temperature required is the summer temperature Summer T°.
The air is not heated unless the temperature is unusually low for the season, falling below the temperature required
Summer T°.
Advice : In the evening, the temperature inside your home is higher than the temperature outside. Use the Temporary
(see §4.1.2) or Rapid mode (see §4.1.3) to refresh your house during the evening in summer.

4.1.1.5. The system is in SUMMER HEAT WAVE mode, during the DAYTIME

The temperature required is the summer temperature Summer T°.
The higher the air temperature, the lower the flow to avoid blowing air that is too hot.
The appliance turns on again when the temperature falls below the Max air T°.

4.1.1.6. The system is in SUMMER HEAT WAVE mode, during the NIGHT TIME

The temperature required is the summer temperature Summer T°.
The system increases the flow within the most pleasant temperature range.
The appliance turns on again when the temperature falls below the Max air T°.
!!! If the appliance is cut off at the end of the day: when night falls, it restarts at the
minimum flow rate. The temperature inside the unit is higher than the temperature outside, hence the system restarts
the ventilator in order to refresh the house.
Advice: 'In the evening, the temperature inside your house is higher than the temperature outside. Use the
Temporary (see §4.1.2) or Rapid mode (see §4.1.3) to refresh your house during the evening in summer.

4.1.2. Temporary:

The flow is kept at a certain value for the required period of time. Called the temporary airflow, this flow and the duration
can be adjusted in the Airflow setting menu (see § 4.2). The system switches back to the automatic mode when the cycle is
finished.
Usage examples : • Reducing the flow before going to bed so there is less noise.
• Eliminating disagreeable odours (cigarette smoke, cooking...)
• Refreshing the home on a summer evening
4.1.3. Rapide:
Maximum rate of flow for an hour. The system switches back to automatic mode when the cycle is finished. This should be
used so as to select another flow and/or another duration.
Usage examples: • Eliminating disagreeable odours (cigarette smoke, cooking...)
• Refreshing the house on a summer evening

4.1.4. Absent:

Select this mode when you are going to be away. The flow is the general airflow (see § 4.2.1). The temperature required is
adjusted to a certain temperature called Absence T°. This can be adjusted in the Temperature setting menu (see § 4.3).
Remember to select the automatic mode when you return home.
When the house is empty there is no need to heat everything, while the ventilation system continues to operate. This mode is
similar to the automatic mode but the temperature required is lower, thus helping to boost the energy efficiency opportunities.

4.1.5. Summer:

The system switches to summer mode and switches back to automatic mode when the season changes or during a power cut.
As the changeovers between the summer and winter modes are scheduled for set dates, selecting this mode brings forward or
extends the summer mode.
43