Behringer CAT Mode D'emploi page 25

48
CAT
CAT Eurorack Installation
Step 5: Eurorack
(EN)
Installation
The CAT synthesizer can be removed from its factory chassis
and installed into a standard Eurorack chassis (not supplied).
The module width is 70HP.
We recommend that this procedure is undertaken only by
experienced service technicians, to prevent personal injury, or
damage to the unit.
The Eurorack case will need its own suitable power supply unit to
power the CAT synthesizer.
A 10-pin connector on the rear of the main PCB of the CAT allows
the +12 VDC power supply connection to be made. A 10-pin
to 16-pin adapter ribbon cable is supplied to connect to your
power supply.
Before proceeding, make sure that your power
supply is capable of supplying +12 VDC, 1 Amp.
Make sure that the connections using the supplied
adapter cable will supply the ground and power to
the correct pins of X17.
Procedure
Follow all steps in the order in which they are presented.
1. Disconnect the power cord and all other
connections to the CAT.
2. Undo the 8 screws on the top panel as shown. There is no
need to undo any other screws.
Disconnect from
Main PCB
3. Disconnect the cable from the lower side of the main PCB of
the CAT and remove the assembly from the chassis.
4. Store the chassis assembly and the power supply adaptor in
a dry safe place.
5. Securely connect the 10-pin end P1 of the supplied adapter
cable to connector X17 on the Main PCB of the CAT.
X17 No Connection
Pins 9 and 10
+12 VDC
X17
Pins 3 to 8
Ground
Pins 1 and 2
No Connection
Supplied Eurorack Power Supply Cable, Part # A74-00001-79446
Connect End P1 to Connector X17 on main PCB
P1 P2
Red Stripe
2 1 1 2
10 9
15 16
400 mm ± 10
6.
Make sure your power supply is turned
off and disconnected from the AC mains.
7.
Make sure that your power supply
will supply the following to the pins of connector
X17, as shown in the diagram above:
Pins Connection
1 and 2 No Connection
3 to 8 Ground
9 and 10 +12 VDC
8. Securely connect the 16-pin end P2 of the supplied adapter
cable to your power supply, and double check all connections
are correct.
9. Securely install the CAT Synthesizer into your Eurorack, using
8 screws in the front panel.
10. Perform a full test and safety test before using the CAT.
11. The 3.5 mm MAIN OUT connector on the top panel is used
instead of the ¼" rear outputs which are no longer present.
CAT Setting the MIDI Channel
Step 6: Setting the
Setting the MIDI Channel
(EN)
MIDI Channel
Please use the SynthTool.exe app to configure the MIDI Channel number.
The MIDI Channel number is saved based on the user configuration, and Channel 1 is not
automatically selected.
All MIDI Channel number changes are handled by the user.
49
Quick Start Guide