Urmet 1067 Mode D'emploi page 6

During normal operation, by pressing the programming button, the board runs a short LED sequence,
which specifies the address acquired.

The IP interface board Ref.1067/014 being acquired, is recognised by the system 1067 as a keypad
and the first available address is assigned to it. Pay attention to the number of keypads already present in
the system. The maximum number allowed is 8 (e.g. if a board is acquired there may be up to 7 keypads in
the system).
Device network parameter configuration
The device can work both either with Ethernet network or with WiFi using your home network or one
available in DHCP mode. By default, the device is set to be configured to a Wi-Fi, setting "Network Name"
and "Password".
If you used the Ethernet cable, the WiFi connection is automatically excluded.
Proceed as follows to configure:
Power the control unit, if you have chosen to connect it to your home network via cable (Ethernet), connect
it to the connector on the device (see legend Fig. 1).
Start the Urmet Secure application previously installed and proceed as follows:

Press the "Other" button.

Select the "Add Device" menu.

Follow the instructions which will appear on the guided menu.
If all the parameters were programmed correctly, the device is ready to be managed via the Urmet Secure
App.
6
Reset and
Programming button
DS1067-107A