Led Operation - Urmet 1067 Mode D'emploi

RESET OF THE DEVICE
Proceed as follows to reset the device:

From any keypad in the system, enter the Installer code in the "Maintenance" menu and delete the
device from the "Delete/Keypads" menu (the device was previously acquired as a keypad, delete the
one with the correct address. For more information, refer to the 1067/xxx control panel installation
manual).

Disconnect the power supply of the device and reconnect it.

Hold down the programming button (PROG) for at least 10 seconds until the green LED lights up
fixed. Now release the button.

The green LED will remain fixed for a few moments and then flash once a second.

The device has performed the reset parameters.

At this point the device is ready to be acquired again.
Led

LED OPERATION

 After a hardware reset, the LED on the board will blink for 10 seconds as for the keypads.
 Board reset in Access Point mode, not acquired by control panel:
 1 blink approximately every 2 seconds.
 Board reset in Access Point mode, acquired:

2 slow blinks with an interval of 8 seconds between sequences.
 Board connected to WiFi/LAN:
a. Network/IP address acquisition
 2 slow blinks with an interval of 1 seconds between sequences.
b. Acquired network, searching for Urmet Cloud/certificate
 3 slow blinks with an interval of 1 seconds between sequences.
c. Network acquired, Urmet Cloud/certificate acquired
 3 slow blinks with an interval of 8 seconds between sequences.
DS1067-107A
Flashes / Description
Reset and
Programming button
The Ethernet connector is to connect
exclusively to the modem/router.
7