Abus Terxon MX Instructions D'installation page 119

1A AUX fuse for
the power supply
2A BAT fuse for the
battery charging
Kick
AC
Star
connectio
Programmable
floating relay
output (NC/NO) /
24VDC@1A
Programmable transistor output (OP).
Max. power consumption of all
transistor outputs 0.5A.
Connection
AC mains supply unit (AC IN)
Kick Start jumper (KS)
Battery contact (+ -)
COMMS interface
Reset jumper (NVM RST)
Fuses (BAT F-2A / 12VAUX
F-1A)
Siren sabotage input (TR)
Optional loudspeaker (LS)
Local download connection
(SK1)
Connection for the telephone
connection (RJ11 + A/B /
A1/B1)
COM
interface
NVM
Battery
tamper cover
connectio EEPROM
contact
Tamper input for
ext. components
12V power supply for
components (e.g.
Meaning
Contact for 230V main supply unit
Connect the two contacts of this jumper to start the alarm centre without a 230V mains power
supply.
Connecting plug from standby power supply
Contact for additional transistor outputs
Connect the two contacts of this jumper to reset the alarm centre.
Always use fuses of the same type. To avoid problems, make sure there is always a good
contact between the fuse holder and the fuse.
For sirens with their own power supply, connect this input direct to the tamper output of the
siren. Otherwise, connect the tamper contact of the siren to the loop between the TR input
and 0V. If no siren is used, connect the TR input direct to the 0V output.
Connect a 16 Ohm loudspeaker for internal alerts.
You can connect a local PC here. The alarm centre can be configured using the downloader
program.
RJ11 connection/screw connections for the telephone line
Local
Download
-
connectio
Alarm zones 1 – 8 for NC aöarm contact
(e.g. IR detector). No NO contacts can be
connected. Make sure alarm zones are
terminated with correct resistors. Two
different resistors, or no resistor, must be
used depending on the programming. If the
zone is used then the wire bridge should be
removed.
15
Connection for
telephone
connection
control unit
UK