Information To User - Ortovox F1 classic Mode D'emploi

RANGE
Due to laws of physics the range of the transceivers depends on their relative posi-
tion to each other. If the transceivers are positioned unfavourably, the range can
be reduced considerably. This can be partially amended when pivoting the receiving
beacon. A maximum range can only be achieved when the longitudinal axis of both
transceivers are aligned (= direction arrow).
For this reason it is recommended to pivot the ORTOVOX device slowly in all direc-
tions in order to get the best receiving position. However do not change your sear-
ching path while doing so.
The function can be disturbed by: • thunderstorms
After a few seconds the display will correct itself. It also can be corrected by swit-
ching the transceiver off and on again.
For exercises we recommend to avoid places of such interferences.

INFORMATION TO USER

This equipment has been tested and found to comply with the limits for an intentional radiator pur-
suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and if not installed and used in accordance with the instructions may
cause harmful interference to radio communications. However, there is no guarantee that interfe-
rence will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• ski lifts
• power lines/power stations
• mobile phones and radios
E
31 23