Bosch UniversalDetect Notice Originale page 28

28 | English
Cause
Interfering objects are within
the sensor range (6)
Ambient temperature too
high/too low
Strong temperature variation Allow the measuring tool to reach the correct temperat-
The measuring tool monitors correct operation in every measurement. If a de-
fect is detected, the display will indicate only the symbol shown opposite. In
this case, or if you are unable to rectify an error using the other corrective
measures mentioned, send the measuring tool to an authorised Bosch after-sales service
centre.
Error during measurement using <Wood> operating mode
Cause
Light-up ring lights up red even though there are no wooden beams in the wall.
Water-filled plastic pipe
Wall is not a dry wall
Inhomogeneous dry wall
Measuring tool placed onto
the wall very slowly
Uneven contact with the wall When taking measurements, always hold the measuring
No wooden beams are found.
Measured section too short
1 609 92A 6H8 | (02.07.2021)
Corrective measures
Remove all interfering objects (e.g. watches, bracelets,
rings, etc.) from within range of the sensor (6). Do not
hold the measuring tool close to the sensor.
Only use the measuring tool in the operating temperat-
ure range.
ure.
Corrective measures
Water-filled plastic pipes in dry walls are also displayed
in <Wood> operating mode.
<Wood> operating mode is only designed for dry walls.
Dry walls made from coarse chipboard can be highly in-
homogeneous and cause incorrect measurements. For
this reason, start the measurement at a different place
on the wall and measure at a different height. If this does
not help, hold an additional plasterboard panel on the
wall and perform the measurement on this.
Place the measuring tool onto the wall quickly.
tool so that contact with the wall is as even as possible
and do not tilt the measuring tool.
Start the measurement at a different place on the wall
and move the measuring tool over a larger section.
Bosch Power Tools