Tools Required - L.B. White Tradesman CP400DK Manuel D'utilisation Et D'instructions

DIMENSIONS & ASSEMBLY (cont.)
Wheels
F F i i g g u u r r e e 3 3 – – C C o o m m p p o o n n e e n n t t s s
ASSEMBLY FOR CP400DK

TOOLS REQUIRED

• Medium Phillips screwdriver
• Adjustable wrench,
ASSEMBLING WHEEL & HANDLE
1. Slide threaded axle through the rear section of the
wheel support frame.
2. Slide one axle bushing on to each side of the axle.
Slide one wheel on to each side of the axle.
3. Attach one cap nut on to each side of the threaded
axle and tighten well
4. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater is over
wheels. Align the holes on fuel tank flange.
Insert screws(L) through handles (front and Rear),
fuel tank flange, and wheel support frame.
Insert screws(S) through rear handle,
fuel tank flange, and washer(S) as shown in
figure 4 and attach nut finger tight after each
screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the rear handle with the
mounting hole on the cord wrap.
7. Insert screws through cord wrap, rear handle as
shown in Figure 4 and attach nut finger tight
after each screw is inserted.
8. After all screws are inserted, tighten nuts firmly.
4 8
Screw (L)
Cord Wraps
Cap Nuts
Front Handle
Wheel Support Frame
Fuel Tank Flange
Wheel Support Frame
Cap Nut (L)
F F i i g g u u r r e e 4 4 – – W W h h e e e e l l a a n n d d H H a a n n d d l l e e A A s s s s e e m m b b l l y y
Screw (S)
Bushing Washers Cap Nuts(S)
Rear Handle
Threaded Axle
Do not operate heater without support frame fully
-
assembled to tank.
Handle
Wheel
Nut
Bushing
Nut
CAUTION
Risk of fire or explosion
Screw (L)
Cap Nut (S)
Screw (S)
Air Inlet
Washer
Threaded Axle
Cord Wrap
Screw (S)