L.B. White Tradesman CP400DK Manuel D'utilisation Et D'instructions page 10

DIMENSIONS & ASSEMBLY (cont.)
Wheels
(Solid Type)
F F i i g g u u r r e e 7 7 – – C C o o m m p p o o n n e e n n t t I I d d e e n n t t i i f f i i c c a a t t i i o o n n
ASSEMBLY FOR CP650DK
TOOLS REQUIRED
Adjustable wrench
ASSEMBLING WHEEL & HANDLE
1. Slide threaded axle through the rear section of the
wheel support frame.
2. Slide one axle bushing on to each side of the axle.
Slide one wheel on to each side of the axle. Attach one
cap nut on to each side of the threaded axle and
tighten well.
3. Loosen 4 screws on the front handle in order to
remove handle front.
4. Move the removed handle front to the handle on
the front side as Figure 8, and then tighten 4
screws after matching handle and handle front.
4 10
Cap Nuts Bushing
Screw
F F i i g g u u r r e e 8 8 – – W W h h e e e e l l a a n n d d H H a a n n d d l l e e A A s s s s e e m m b b l l y y
Front Handle
Threaded Axle
Do not operate heater without support frame fully
-
assembled to tank.
User Assembly
Nut
Wheel
Cap Nut
Handle Supporter
Wheel Support Frame
CAUTION
Risk of fire or explosion
MOVE
Threaded Axle
Bushing
Handle
Frame
Threaded Axle