To Restart Heater; Longterm Storage Of Your Heater - L.B. White Tradesman CP400DK Manuel D'utilisation Et D'instructions

OPERATION (cont.)
TO STOP HE TER A
Never unplug heater while running.
-
Heater must go through cooling cycle. The cooling cycle cools the
combustion chamber. Damage to heater can occur if combustion
chamber is not cooled. Do not restart heater until cooling cycle is
complete.
1. Turn operating switch to "OFF". This will cause heater flame to go
out.The motor will continue to run during the cooling cycle.
(Room Temp. Display will show "CC" during the cooling cycle).
This allows the fan to cool the combustion chamber. When the
cooling cycle(approx.1Min) is finished, the motor will stop. Do not
unplug heater until cooling cycle is finished.
2. Unplug power cord.
3. To temp orarily stop heaters, set thermostat at a temperature
lower than air around heater, Heater will cycle back on if air
temperature around heater matches thermostat setting.

TO RESTART HEATER

The cooling cycle cools the combustion chamber.
DO NOT restart heater until cooling cycle is finished.
-
1. Wait until cooling cycle is finished after stopping heater.
2. Repeat steps under TO START HEATER.
Shock hazard
Always cover outlet when not in use.
-
PIGGYBACK POWER CORD
(For CP400DK only)
• Always cover electrical outlet when not in use. See Figure 11.
• Don't plug and use an appliance with more than 5A current in this
outlet.
Figure 11 – Piggyback Power Cord
CAUTION!
CAUTION!
WARNING!
Cover
Electric Outlet
LONG-TERM STORAGE OF YOUR HEATER
FUEL TANK DRAIN
1. Remove drain bolt from bottom of fuel tank . See
Figure 12.
Figure 12 – Drain Plug Removal
2. Using a small amount of kerosene, swirl and rinse the
inside of the tank.
NEVER MIX WATER WITH KEROSENE, as it will cause rust inside
the tank. Pour the kerosene out, making sure that you remove it
all.
IMPORTANT:
Do not store kerosene over summer for use during next heating
season. Using old fuel may damage heater.
Tighten drain bolt firmly into the tank, otherwise it will not
seal completely.
- Make sure storage place is free of dust and corrosive fumes.
- Store the heater in the original box with the original packing
material and keep USER'S MANUAL with heater.
Seal
Fuel Drain Bolt
4 13