Machine Setup; Operating The Machine - Clarke FM40 ST Mode D'emploi

MACHINE SETUP

To prepare the machine for use follow this procedure:
1 Familiarize yourself with the machine. Read all danger, warning, and caution statements and the Operation and Parts Manual before

operating the machine.

2 Install or replace the Pad (10). The pad should be replaced if it has become matted down to a thickness of 3/8" (9.5mm) or less. To install or
replace the pad, follow these instructions:
a.) Lock the Operator Handle (6) in the upright position.
b.) Tilt the machine back until it fully rests on the Handle (6).
c.) Standing over the machine, remove existing pad then center new pad over grip face.
d.) Press Pad (10) against grip face until the hooks in the driver have set in the pad. See Figure 3.
e.) Return machine to the upright position.
CAUTION!
Damage to the grip face will occur if the machine is operated without a pad or with a pad that is 3/8" (9.5 mm) or thinner.
WARNING!
Never put yourself or let others be in a position to get injured if the machine should tip or fall, while replacing the pad or changing abrasive. Injury
can occur if the machine is connected to a power source while installing the pad or abrasive. Disconnect the machine before installing the pad or
abrasive.
2/2015
INSTRUCTIONS FOR USE
FIGURE 3
56091153 - FM40 ST, FM40 LX
10
ENGLISH - A
A-7