Operating Instructions - Scrubbing - Clarke FM40 ST Mode D'emploi

OPERATING INSTRUCTIONS - SCRUBBING

To operate the machine as a scrubber, follow this procedure:
1 Move machine to work location. Decide the best approach to scrubbing the desired area. When scrubbing the area, work so that you are
moving away from the power supply. This will help to avoid entanglement with the power cord and reduce the need to move the power cord
as frequently.
2 Follow the procedure outlined in MACHINE SETUP for installing the pad.
WARNING!
Injury can occur if the machine is connected to a power source while installing the pad. Disconnect the machine before installing the pad.
3 Connect the machine to an appropriately fused and grounded circuit.
4 Release the handle by pulling up on the Handle Release Compression Lever (4). Bring the handle to a comfortable position, and lock the
handle.
5 See Figure 4. Push the Switch Lever Safety Lock Button (2), and apply pressure to the Switch Levers (3). To stop the machine, release the
Switch Levers (3).
CAUTION!
To prevent damage to the fl ooring and to reduce swirling, keep the machine in motion while the motor is running.
FM40 LX – SWITCHING BETWEEN WHEELS-UP AND WHEELS-DOWN OPERATION
This model may be operated with the rear wheels up so that the pad deck is fl oating. Or it may be operated with the wheels down and in contact
with the fl oor. In the down position, the machine moves forward and backward much like a lawn mower and is more controllable and less
fatiguing. To switch between wheels up or wheels down position, activate the Lever (8) as shown in Figure 5 while applying pressure on the
handle to lift the wheels.
Apply Forward Pressure
When Engaging Switch (8)
2/2015
INSTRUCTIONS FOR USE
FIGURE 5
8
56091153 - FM40 ST, FM40 LX
ENGLISH - A
A-9